How to install the gear reducer motor
2021-04-15 16:46:32   |  How to install the gear reducer motorHow is the geared motor installed?
1. Installation of reducer
The reducer (motor) can only be installed on a flat, shock-absorbing, and torsion-resistant support structure according to the specified installation position; the bottom of the box and the mounting flange cannot be tightened at the same time during the installation process to avoid mutual competition;
When using bolts or foundation blocks to fix the reducer (motor) on its concrete foundation, there should be a suitable groove to accommodate the reducer (motor);
When installing, please check whether the amount of oil is consistent with the installation position. If the installation position changes, please adjust the oil amount accordingly;
Install a straight-through ventilator or open the ventilator to transport the rubber ring;
Do not hit or knock the shaft end;
The vertical installation of the motor should have shielding measures to prevent foreign objects or liquids from intruding (rain cover C);
When installing the junction box, make the cable inlet point downward.
2. Installation of solid shaft reducer (motor)
Install and fix input and output drive parts (such as coupling parts, etc.) on the shaft of the gear reduction motor;
If these parts need to be preheated before installation, the correct temperature is required;
The misalignment of the shaft may be caused by assembly or actual operation (such as thermal expansion, shaft deflection, insufficient rigidity of the frame, etc.);
For the permitted alignment error of the coupling, please refer to the manual of the corresponding brand coupling.