What preparations need to be done before the installation of the gear reducer motor2021-04-15 16:43:00   |  What preparations need to be done before the installation of the gear reducer motor
How is the geared motor installed and debugged?
1. Precautions before installation
The assembly and installation work must be carefully carried out by trained and qualified personnel; at the planning stage, enough space should be reserved for the gear reducer motor for future maintenance and repair work; before the start of assembly and installation Be sure to prepare suitable lifting equipment before work; if the reducer (motor) is equipped with a fan, there should be enough space to be able to suck in air; the description on the nameplate of the transmission is consistent with the on-site power supply; the transmission should be intact Non-destructive (not damaged during transportation or storage);
Confirm that the following requirements have been met
For standard reducers: ambient temperature 0 °C+40 °C, no oil, acid, harmful gas, steam, radioactive objects, etc.;
For special types: the transmission device is configured according to environmental conditions;
For worm gear reducer: It is not allowed to impose too large reverse external moment of inertia on the reducer with self-locking function, so as not to damage the reducer;
In order to ensure good lubrication, the installation position specified in the order must be observed;
Be sure to pay attention to the warning and safety signs of the reducer (motor).
2. Preparation before installation
Use commercially available solvents to thoroughly remove preservatives, dirt or the like on the surface of the output shaft and flange;
Note: Do not immerse the solvent on the sealing lip of the oil seal, otherwise the solvent may damage the oil seal;
If the reducer is stored for more than 1 year, the service life of the lubricant in the bearing will be shortened;
If the filling is mineral oil or synthetic oil (CLPHC), and the filling amount is consistent with the requirements of the installation position, the reducer can be operated at any time in this case. However, check the oil level before starting;
In some cases, synthetic oil (CLPPG) is added, and the oil level is higher. Correct the oil level before starting.